Notes:  Please give us as much information as possible 

Quantity
required

Material
 

                  
Steel, SS (stainless steel), HTS (hardened & tempered steel), Aluminum, Brass, Clear Plastic, etc...

Ruler length

Ruler width

Ruler
thickness

Graduations
&
any comments

                  
Engraving--Graduations & Numbers (in case of rulers-please specify whether one or both sides of the ruler are to be engraved and in what increments; plus how many edges--one, two, three or four.  Also, please specify the orientation of the markings--reading left to right or right to left; and orientation of the numerals--horizontal or vertical.  You can supply details in note form, however, a simple sketch is often easier to understand)